Quantcast
Now We’re Cooking…

DSCN0815

For the faithful converts of ultralight backpacking, the alcohol stove might just be the Holy Grail. Almost all of the long-distance hikers I know have long-since traded their clumsy Whisper Lites and wasteful Pocket Rockets for the stove that you can make in your basement. The alcohol stove goes by a variety of names, including pepsi can stove and beer can stove, depending on how it’s made, but the basic principle is the same. You cut the bottom off of two aluminum cans, fit them together, cut out a large hole for your fuel, and punch about fifteen little holes around the rim for the flame to escape. A metal stand, which you can also make yourself, holds your cookpot above the flame. A lot of people use pot cozies to continue cooking their food after the flame goes out so that they don’t waste fuel unnecessarily.

Stove 2

But the alcohol stove isn’t just a lighter alternative; it’s also a greener one. It runs on denatured alcohol rather than, say, isobutane-propane (which, when burned, is known to cause cancer, birth defects and other reproductive chaos), it uses recyclable materials, and you can make it yourself. For people like me, whose engineering skills are suspect, you can also buy them online at Anti Gravity Gear, Mini Bull Design, and Mo-Go-Gear. Sometimes you can find them on Ebay as well.

Alcohol stoves weigh as little as a half an ounce, plus the weight of however much fuel you carry. (Denatured alcohol is often sold in small quantities at outfitters and hardware stores in trail towns.) You won’t be making three course meals with this stove, but do you really want to lug all that food with you anyway?

Comments
  1. starre said:

    I love it! My propane stoves always sucked anyway. I want to try one of these….I can’t believe how little they weigh.

  2. Socialpyramid said:

    Awesome! Simple, decentralized, elegant, recycling. I have had nothing but trouble with complicated Whisper Lites, which seem to have more parts than a VCR, and constantly stop working after clogged. I do not enjoy poking around in them trying to get them working again. On the other hand, after two uses my single-burner pressurized propane stove started dispensing two flames, one where you want it to cook your food and the second at the joint of the fuel-line to the stove. This did not make me happy.

  3. Sam said:

    I’d say the construction is pretty clean, except for the center fuel port (the dome that you have to cut out). I use epoxy to seal my stoves, but I’m experimenting with making stoves without epoxy. I’d also suggest that you experiment with pressurized designs because you would then eliminate the need of a potstand. An alternative, is making an open jet side burner. It’s basically the same as the stove here, just with the burner holes on the side of the stove, instead of the “ridge”. This design also allows you to place a pot directly on the stove.

  4. Sam said:

    Here’s my website if you want to learn how to make these stoves:
    http://www.homemadealcoholstoves.co.nr
    Happy stove building!

  5. Sam said:

    I also recomend that instead of using denatured alcohol, you use HEET. This fuel is sold as gas line antifreeze. HEET is 100% methanol, and burns very clean. Denatured alcohol varies from batch to batch, and will contain anywhere from 1% methanol to 80% methanol and a bunch of other toxic chemicals. Always buy HEET in the YELLOW bottle. The red bottle is IsoHEET and is made from isopropanol (rubbing alcohol) and leaves a bunch of soot on your pots. So Always Go With HEET!
    HEET IS AWSOME!!!

  6. Uta said:

    There are other similar designs that may work better and are easier to construct. Those interested should spend some time at http://zenstoves.net/Stoves.htm to get their fill of eco stove information.

  7. Sam said:

    I was also wondering. In the first picture, it shows what appears to be a half circle punched in the inner wall. If you could tell me what it is, and what its for, that would be great.

    Thanks

Comment on this entry